Refill the generator with fuel and oil as needed, and return the generator to its compartment. Figure 2-2 Commander C200/C300 keypad detail. Allow the generator to cool for _ minutes.Ĩ. Chief Stephenson is a 21-year veteran of the fire service, having served as a Fire Specialist II with the City of New Bern Fire Department, and 19 years with. Failure to observe the instructions could result in a fire hazard. Clean all power cords, plugs, adaptors, GFIs, and tools, and replace them in proper storage areas. Disconnect all power cords and junction boxes, and remove the grounding rod if present.ħ. Allow the generator to (current) for approximately _ minutes before turning it off.Ħ. Under the authority, direction, and control of the USD(A&S), the ASD(S) will: a. ASSISTANT SECRETARY OF DEFENSE FOR SUSTAINMENT (ASD(S)). Turn off the load and listen as the generator slows down to _ speed. Provide criteria, guidance, and instructions to incorporate fire suppression, fire prevention, and emergency service elements in appropriate DoD program and budget documents. Run the generator under load for _ to _ minutes.ĥ. Check the voltage and amperage gauges to confirm efficient operations.Ĥ. Connect the power cord or junction box to the generator, connect a load such as a fan or lights, and make sure the generator attains the proper speed. Check the oil and fuel levels, and start the generator.ģ. Remove the generator from the apparatus compartment or open all doors as needed for ventilation. To conduct a weekly/monthly generator test, follow these steps:ġ. Apply foam using one of the three application methods (Which are?)
#Fire commander ii installation manual
The hose line is now ready to be advanced onto burning flammable liquids.ĩ. For detailed information on installing peripheral and hard- wire devices, see the Commander 2000 Reference Manual and the installation sheets that accompany. Flow water through the hose line until foam starts to come out of the nozzle. Charge the hose line with water, ensuring there is a minimum of _ psi at the eductorĨ. Place the pickup tube from the eductor into the foam concentrate, keeping both items at similar elevations to ensure sufficient induction of foam concentrateħ. Place the foam concentrate container next to the eductor, check the percentage at which the foam concentrate should be used (found on container label), and set the _ on the eductor accordingly.Ħ.
Place the in-line eductor in the hose line no more than _ feet from the nozzle.ĥ. Procure an attack line, remove the nozzle, and replace it with the _ nozzle.Ĥ. Ensure that enough foam concentrate is available to suppress the fire.ģ.
Make sure all necessary equipment is available, including an _ foam eductor and an _ nozzle. To place an eductor foam line in service, follow the steps:ġ.